For 2 and 3 Wheel Tabletop Band Saws; 1/4" Width; 14 Raker Tooth; 0.014" Thickness The Three Wheeler bandsaw blade is a special blade for 2 or 3 wheel tabletop bandsaw. Blade breakage and poor blade performance are common problems with these small saws. These problems are caused by the extreme flexing of the blade caused by the small size of the wheels that the blade runs on and the high speeds normally used. The Three Wheeler blade is made of special Carbon Tool Steel with Carbon Tool Steel precision heat-treated teeth that is thinner (.014") in order to enable it to withstand sharp flexing and high speeds. There may be a number of other bandsaws or models that use the same blade lengths as the ones listed: 56-7/8 inch ( 4 ft. 8-7/8 inch, 4' 8-7/8" ) bandsaw blades suit the following models: 10" Craftsman V.S. 24453 Single Speed 24460, Shopcraft and Duracraft VS312 BBS412. If in doubt, to determine bandsaw blade length: 1 - Check the owner's manual of your bandsaw machine for specifications - not only the length, but also the range of the width and thickness.2 - If the owner's manual is not available, refer to previous invoices.3 - Cut your old bandsaw blade so that it lies flat on a level surface, and measure its length. This method will provide the most possible accurate length.4 - Upon requested, Magnate makes blades of any length and types to fit your brand and model.