Master Tailgaters Replacement for Ford Flex 2009-2012 Emblem WITH Backup Reverse Camera ( Full Color Camera) COLOR: Chrome For use with( Years): Ford Flex (2009-2012)* *Note- Prior to ordering, measure your current emblem. This replaces all Ford large oval emblems located at the center of the tailgate. Installation: This backup camera can be connected to any aftermarket monitor with a Yellow RCA input. Typically the factory emblem is attached to your truck with double sided tape. Use a heat gun, at a low heat setting, and use a piece of floss between the emblem and tailgate to remove the old emblem. On some older models, you may need to drill a small hole in your tailgate to run the wiring through. Most 2006+ models come with the holes already drilled. Description: This is an Genuine Ford Emblem (part #CL3Z-9942528-B), aftermarket Chrome base, and backup camera. For the power supply, you can connect it to any 12V power source. For example, if you wanted the camera to always be on, you can connect it to a 12v source that is on all the time, or if you only want it when you reverse you can connect it to the reverse taillights. Includes video and power extension cable, 8 Meters(26 feet). *Ford Genuine mounting screws and clips included! Camera Specs: Sensor: OE? On-Semi (USA) CMOS Active Pixel Array, Lens: Nidec (Japan) (Glass + Plastic) Minimum Illumination : .1 Lux light sensitivity Signal System : NTSC/PAL Effective Pixel : NTSC: 728 x 582 Video Output : 1.1Vp-p 75 Ohm Electronic Shutter : 1/50 to 1/100,000 seconds Resolution : 600 TV line Angle : 170 Degree Waterproof Rate : IP68 Current Consumption : 120mA Max. Power : DC 12V Video Cable Length : 8 Meters Attention!!!: -Before purchasing check the back of your Monitor/Screen that you have a Yellow RCA input for easy installation. - This is mainly for Aftermarket monitors and NOT for OEM replacements. -Installation is still possible without the Yellow RCA, however it is much more difficult and will require a professional to splice in the Video In signal.