Stand up in front of your competition with a 3D look on your designs.
White Foam Backing for 3D look
Puff
Measurements 18 X 12 X 3mm
Color White
Makes your embroidery stand out buy adding dimension to your embroidery design.
How do I sew a puff foam / 3D embroidery design?
The process of embroidering with puffy fonts, logos and designs is slightly different than regular embroidery, but not much harder. First off, know that there are more costs, and more stitches, in designs using BCK3D.
When sewing it is as simple as:
- Sew all your flat embroidery first.
- Create a stop in the machine after your last flat piece
- Place puff over area you want it sewn and restart the machine
- Sew a border around your puff area
- Remove excess puff material
- Finish design and clean up excess puff foam material.
Some basic tips to getting started right with foam embroidery:
- The digitizing is important. You will need to have longer stitches to make up for the space the foam is taking. .
- Learn how to program stops in your machine. You should be able to put a stop in after a certain color change.
- Lay the foam down and use tape or EZADH EZ Stick Spray Adhesive to hold it in place. Once the first stitches go into the foam, you won’t have to worry about it moving anymore.
- Outline the area of the foam first, then sew satin stitches. This outline will help create a ‘cut’ in the foam to easily pull it off.
- Now stop the machine and tear off the excess foam
- Complete the rest of the embroidery and cover the foam area.
- Once you are done with the design you can use nippers or a heat gun to clean up any excess foam. Nippers are good for a piece that didn’t tear well. The heat gun is good for shrinking the foam into place and creating that tight and clean look.
- Foam works best on designs that have a good underlay border and satin stitches across the foam. Note that any design cannot be done in foam. For example, a heavy fill stitch over foam or too much underlay might not give the desired look.
- Use of a sharp point needle can help tear into the foam and give a clean cut. Be sure to use the backing you normally would on a design. Backing is important to give stability to this type of embroidery.