About this item
- Fits the Following Vehicles: The 700182 blower motor fit for Audi A3 (w/o ATC Hatchbac) 2006-2013, Fits for Volkswagen CC (w/o Climate Control Sedan) 2009-2014, for Eos (w/o ATC Convertible) 2007-2014
- Fits for Volkswagen GTI (Body: A5 Hatchback) 2006-2009, for Jetta (w/o ATC Wagon) 2009-2014, for Passat (w/ Climate Control Wagon) 2006-2010, for Rabbit (w/ Climate Control Sedan) 2006-2009
- Superiority: comparable assembly complete with motor and fan (wheel) to save installation time and cost. Fans (wheels) are pre-balanced with the motor to ensure perfect assembly and performance.
- Durable & Safe: Our Blower Motor Resistors use imported copper core socket to prevent poor contact and prevent the current too large and burn the blower, have the advantage of impact resistance, heat resistance, aging resistance and high hardness.
- Comprehensive Testing: Outstanding materials and sub-components provide maximum strength and durability. The motor has inspection before delivery, including noise, vibration, current, speed, low voltage start and so on.
- Buyer Notice: Match the original car perfectly. Please verify Fitment or Application.
*The AC Blower Motor is responsible for producing air that goes through the vents of your vehicle's AC and heating system.
*If your AC or Heater does not produce or circulate any heated or cooled air then you may have a problem with your blower motor.
*Step up from the ordinary, It is time to replace the blower motor that has stopped running.
*Fit for Volkswagen CC 2009-2014 (Fit Notes: w/ Climate Control Sedan)
*Fit for Volkswagen Eos 2007-2014 (Fit Notes: w/o ATC Convertible)
*Fit for GTI 2006-2009 (Fit Notes:Body: A5 Hatchback)
*Fit for Passat 2006-2010 (Fit Notes: w/ Climate Control Sedan)
*Fit for Passat 2007-2010 (Fit Notes: w/ Climate Control Wagon)
*When you replace the blower motor, it is recommended to replace the new blower motor resistor.
*Please use the year/make/model drop down bar confirm the compatibility before purchasing.
Weak airflow for both the heating and cooled air coming out of the vent
No air pushing through the vents (motor broken down or bad control module)
Unusual blower noise such as a rattle or squeak (worn motor or bad bearings)
If you have an overheating blower motor, would be a burning smell coming from your air vents
Material of rotor punching plate is silicon steel sheet,avoid burning of motor
1.Remove the screws under the passenger side dashboard of the vehicle.
3.Disconnect the blower motor electrical connector.
5.Compare the new blower motor to the old one to verify that you have the correct part.
6.Install the new blower motor into the box and tighten the screws.
8.After the installation is complete, turn on the air conditioner and check if it is running normally.