Description

This is a DIY product with vector network measurement function. It includes a 2.8-inch touching screen, TX/RX measurement, can determine the complete S11 and S21 parameters, if you need to get S12 and S22, you need to manually replace the trans-ceiver port wiring.

Parameter

- Product Name: Vector Network Analyzer
- Color: Black
- Measurement frequency: 50KHz ~ 300MHz (50KHz -900MHz, enable extended firmware)
- RF output: -13dbm (maximum -9dbm)
- Frequency accuracy: <0.5ppm
- Measurement range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware)
- Port SWR: < 1.1
- Display: 2.8 inch TFT (320 x240)
- USB interface: USB type-C
- Communication mode: CDC (serial)
- Power: USB 5V 120mA, built-in 400mAh battery, maximum charging current 0.8A
- Number of calibration points: 101 (fixed)
- Number of scanning points: 101 (fixed)
- Display Tracking: 4, Marking: 4, Setting Save: 5
- PCB: 54mm x 85.5mm x 11mm/2.12" x 3.36" x 0.43" (without connectors, switches)
- Measuring S parameters, voltage standing wave ratio, phase, delay, Smith chart...

Package Included:

1 x NanoVNA host
1 x USB Type-C data cable
2 x 30mm SMA male to male RG174 RF cable
1 x SMA simple calibration kit
1 x SMA female to female connector