MAGNETIC DELAY
Feature:
Time Knob– This Time control roughly sets the length between your repeats between 40ms and 600ms.This range is well suited for classic,vintage delay sounds that are great for slap-back or medium length delay times.
Depth Knob– Turn this control to achieve deeper and deeper chorusing and pitch shifting on your echoes. As you raise the control the Depth and Rate LED will start to glow giving you a visual indication as to the amount of modulation you are applying to the repeats.
Speed Knob– This is your Flutter control. It's another way to control how poorly your tape echo is performing! Not that any tape deck was every in this bad of condition, but it sure sounds good to have a little pitch modulation on your echo! Using these controls gives you a nice way to create unique and very musical delays.
Regen Knob– This control sets the number of repeats. You can set this for a single slap back echo or turn it up for a runaway, self-oscillating or self-regenerating echoes. (Now go back and twist the Time control for some crazy sounds!)
Level Knob– The Level control is your mix, how loud you want to hear the echoes.
Specification:
-Input Impedance 1MΩ
-Output Impedance 1KΩ
-Power Supply : DC9V 300mA(not included)
-Dimension(L*W*H):11.5*6.5*5CM
-Weight:300g
KING RAT
Description:
Based on PRO CO RAT circuit.
Effect Type: Fuzz distortion
Control:Volume,Filter,Distortion
One Toggle:LM308/OP07DP
4-mode selection knob:Dirty,Vintage,Turbo,Fat
Power Supply:DC9V 100mA -center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
BIG FUZZ
Description:
Based on Electro-Harmonix Big Muff PI circuit.
Effect Type: distortion/Fuzz
Control:Volume.Tone,Sustain
One Toggle:Two Vioce
4-Mode selection knob: π,ToneBender,M,Booster
Power Supply : DC9V 100mA -center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
TRANSPARENT OVERDRIVE
Based on TIMMY and VEMURAM JAN RAY circuit.
Effect Type: Overdrive
Control : Volume,Bass,Treble,Gain
4-Mode selection knob:TIM1,TIM2,M,JAN RAY
Power Supply : DC9V 100mA -center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
GREEN SCREAMER
Description:
Based on Tube Screame TS9,TS808 circuit.
Effect Type: booster/overdrive
Control:Level,tone,drive
One Toggle:Gain
4-Mode selection knob:TS808,SD1,M,TS9
Power Supply : DC9V 100mA -center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
COMPASS DRIVE
Description:
Based on Analog prince of tone circuit.
Effect Type:Distortion/overdrive/booster
Control:Volume,tone,drive
One three modes Toggle:Voice
4-Mode selection knob:OD,BOOST,DIST,M
Power Supply : DC9V 100mA -center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
DOLPHIN DRIVE
Description:
Based on fulltone OCD circuit.
Effect Type: distortion/overdrive
Control:Volume,Tone,Drive
One Toggle:HP /LP
4-Mode selection knob:MOSFET,SOFT,Ge,Si Clipping
Power Supply : DC9V 100mA-center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
LM741 PREAMP
Description:
Based on DOD250,DOD YJM308,MXR Distortion-circuit.
Effect Type: Distortion/overdrive /preamp
Control:Volume,tone,sustain
One three modes Toggle:mxr/d250/yjm308
4-mode selection knob:Si,Ge,Soft,Boost
Power Supply : DC9V 100mA -center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
THE MARKSMAN
Description:
Based on KLON CENTAUR circuit.
Effect Type:Boost/overdrive
Control:Output,treble,gain
One three modes Toggle:Voice
4-Mode selection knob:clipping
Power Supply:DC9V 100mA -center is negative
Dimension(L*W*H):11.5*6.5*5cm
Weight:300g
FLAME CHORUS
SPEED controls the rate of the chorus.
DEPTH controls the width of the chorus, from pretty shallow and subtle to super deep, weird and wacky pitch craziness.
BLEND controls the wet/dry blend between your dry signal and the chorused signal;
Control: SPEED,DEPTH,BLEND
4-MODE SELECTION KNOB
1-VOICE Toggle Switch
True Bypass
Power Supply: 9V DC power -center is negative
Packing Size: 147 (W) x 78 (D) x7(H) mm
Weight:300g
OTA PHASER
RATE | The Rate control is used to sweep through the range of LFO speeds in both modes.
DEPTH | The Depth control can be looked at as a dry/wet mixer. Atits minimum setting you will find very subtle phasing effects (not completely dry) and at its maximum level the phasing effect will be extremely present (very wet) and basically the opposite of subtle.
LEVEL | The Level control is an output volume control, allowing you to perfectly match unity
gain with the rest of your pedal chain or dialin just the right amount of signal boost to make
your phased tones grab everyone's attention.
Control: RATE,DEPTH,LEVEL
4-MODE SELECTION KNOB
1-TONE Toggle Swtich
True Bypass
Power Supply: 9V DC power -center is negative
Packing Size: 147 (W) x 78 (D) x7(H) mm
Weight:300g
PLEXI PRO DISTORTION
Product Introduction:
Based on Classic Marshall Plexi sound
Plexi Pro guitar effect pedal provides plenty of power and a crushing tonal response all in one little stompbox.
Responsive dynamics, harmonics filled sustain to get that famous Plexi "brown" sound without having to buy a giant sized stack.
It is built for guitar heroes, it cleans up if you turn it down, but that's not why you want this pedal. turn the knobs to the right and start wailing away.
Plexi Distortion Pedal for Guitar
The Plexi Pro is modeled to achieve the sound similar to the old Plexi style amps from Marshal. The Plexi faithfully replicates the immediate overdrive tone synonymous with turning the gain up on the Plexi head. Although not the intention at the time, this became the signature sound of Marshall amps for years to come, and a sound the plexi recreates convinceingly.
Volume, Tone and Distortion Control
The Plexi has three controls that can be configured for the particular type of plexi sound required. Having all controls at zero will produce a standard high gain, overdrive at the input stage of an amp sound, whilst turning them all up to eleven will elevate the tone to a screaming, high frequency solo tone for some wild playing. If the middle ground is for you, then all controls at midpoint will give you the solid rock rhythm Marshall type tone that many rhythm guitarists in a rock band seek.
True Bypass Switching
The Plexi has true bypass switching that eliminates any signal interference when switching the pedal on or off.
Gain Switch And 4 Mode Selection Switch
The Plexi has one gain toggle switch and one 4-Mode selection switch ,Provides gain and adds more tone mode options.
Specifications:
Input Impedance: 1MΩ
Output Impedance: 1KΩ
Running Current: 35mA
Effect Type: Distortion
Control : VOLUME,TONE,DISTORTION
One Toggle Switch : GAIN
4-MODE SELECTION KNOB
True Bypass
Power Supply: DC 9V ,Centre Negative
Packing Dimension:14.7(L)X 7.8(W)X 7(H) CM
Weight: 310g
ROLLER COMPRESSOR
SUSTAIN: Adjusts compression ratio and increases SUSTAIN. NOTE :Higher Sustain Setting will create noise whe not playing .
BLEND: Adjusts mix of compressed and uncompressed signal.Full left for 50/50 blend ,full right for full compression.
LEVEL: Adjusts for gain lost to Compression or Blend, Set to unity or turn it up higher for a boost effect.
TONE: Adjusts brightness of output turn right for bright.
Control: SUSTAIN,BLEND,LEVERL,TONE
4-MODE SELECTION KNOB
True Bypass
Power Supply: 9V DC power -Center Negative
Packing Size: 147 (W) x 78 (D) x7(H) mm
Weight:300g
CRUNCH PRO DISTORTION
Control: VOL,TONE,GAIN, PRES
4-MODE SELECTION KNOB
True Bypass
Input Impedance: 1M ohm
Output Impedance: 1k ohm
Power Supply: 9V DC power -center is negative
Packing Size: 147 (W) x 78 (D) x7(H) mm
Weight:300g
MPT-10 POWER SUPPLY
1.One USB 5V1000mA output,used for music led ,cellphone, ipad and other portable devices
2.6 Outputs DC 9V 100mA outputs
3.1 Output DC 9V 300 mA output
4.1 Output DC 9V 500 mA output
5.1 Output DC 18V 100 mA output
6.1 Ouputs DC 4V to 12V adjustable outputs, maximum output current is 100mA
Packing list:
1 *pc MPT - 10 power supply
1 *pc 18v 1000mA power adapter
10*pcs DC Cables
1 *pc reversed polarity
1 *pc 3.5mm Converter
1 'pc owner's manual
TAKE Advantage on VOLUME Purchases $SAVE up to 5% Mix N' Match