*Due to phones or monitors showing color shades differently, colors may vary from what is on your screen.*Keep in mind 3D printed parts will have texture. Think of them like model car parts. May need a light sanding, A xacto knife trimming small supports or paint if you wish. Usually 1 side was attached to the printer bed and it may be the roughest. Lightly sand and usually fine. Thanks again for your interest.
3D printed plastic parts can break if you get too rough wirh them but I've had my battery covers on and off a dozen times wirhout failure. The front tab wont handle a bunch of force so be careful. Do not use tools such as screw drivers to pry them out. It will arrive unbroken. No warranty beyond that.
~~~DESCRIPTION~~~ New 3D printed battery cover for Stomper Semi Cab Over & on/off switch on bottom. There are 3 styles so ask if not 100% sure. The king pin holes slightly different than original but still fits stock trailers. Has slight cosmetic differences to keep it from being mistaken.
Tight fit. A bit stiffer than original with texture shown. I added a small support to help you take the cover on and off easier. Colors close but mot exact. See pics
~When you receive your 3D printed Parts they may have a small amount of Elmer's Glue on the back wash with warm water for use.
Zoom in and judge for yourself. Most of these I stuck a battery in to see if it works but otherwise are as found condition. Sold as is.
Condition is Used. Shipped with USPS
Vintage 80s Stompers like most Electronics can stop working during shipping. Typically you can put a fresh battery in them and tap them on the bottom and they will start working again. Sometimes the solder will come loose which is also easily fixed. Battery not included. Smoke free home!