Item description for FYSETC Spider V3.0 Motherboard 32Bit Controller Board TMC2209 3D printer Part VS

FYSETC Spider V3.0 Motherboard 32Bit Controller Board TMC2209 3D printer Part VS Octopus Replace For Voron 2.4 Voron TridentFeatures

V3.0 Upgraded

1.Added 74HCT365 buffers for all stepper motor drive signals. All the motor drive IO signal voltages are changed from 3.3V to 5V, the driving ability is enhanced, and the external driver connettion is simpler.

2.An onboard CAN transceiver is added to enable the mainboard to communicate directly with CAN devices, no need for expansion boards.

3.A 3.3V power supply indicator is added, and different power supplies are indicated by LEDs of different colors, so that the working status of each power supply on the motherboard can be seen at a glance.

4.The main board has been re-layouted, and all the marks are placed on the top layer, which makes it easier for users to view the marks of the pins and easier for firmware configuration.

5.Connect the BOOT0 and RESET pins of the STM32 to the Pi's IO through the switch (disconnected by default), which provides the basis for directly entering the programming mode through the Pi.

package list:

Board and module 1:Board + WIFI module (external antenna)

Board and module 2:Board + WIFI module (onboard antenna)

With 12864 set 1 :RGB MINI12864 Black on RGB

With 12864 set 2 : RGB MINI12864 White on RGB

set 3 : RGB MINI12864 White on RGB+8pcs TMC2208

set 4 : RGB MINI12864 White on RGB+8pcs TMC2209

set 5 : RGB MINI12864 White on RGB+8pcs TMC5160

set 6 : TMC2209*7pcs + PT100*1pc

set7 :TMC2209*6pcs +HV5160*2

- Compact size: 155.3mm x 76.5mm
- Based on STM32F446 180Mhz, all IOs can withstand 5V voltage
- 8 TMC stepper drivers support, with Uart&SPI support
- Improved TMC jumper settings again, simpler and easier
- 28V input max, 12V@5A DC-DC, 5V@8A DC-DC (Especially for Raspberry Pi), [email protected] LDO
- Two car fuses for hot bed input and main power input
- Limit switch socket 24V/5V/3.3V optional, ready for more other equipment, such as -inductive sensor, BL-Touch
- XH2.54 connectors
- 10x PWM capable power mosfet outputs (1 for HotBed, 3 for Heat-End, 3 for fans, 3 for RGB LED strip)
- 3pin temperature header, you can use thermistor or thermocouple (requires AD597 module)
- Up to 8 ways PWM fans (only use 1 extrueder and no 12V/24V RGB used ), 2 ways RGB led(12V & 24V optional) , 1 way 5V-RGB led (NEO-PIXEL/WS2812)
- RepRapDiscount SmartController compatible pin header on board
- UART1-Raspberry Pi pin header (including 5V@8A power supply)
- 2X4 PinHeader Out for SD Card moudle
- Onboard micro-SD card
- Type-C and Type-B USB connector optional
- EXP1 & EXP2 have more multiplexing functions, such as USART, I2C, CAN
- SD card & USB upload support

SPECIFICATIONS