SUMMARY

• Has never been installed in a car
• From an assembly line left-over console
• Very good condition
• Minor blemishes, if any
• From bumping/resting against a neighbor
• Consoles are hard to store
• OEM factory original 
• 'Platinum' gray appears to be the color
• Has a leather top 
• Has perforations on the rear
• See the photos
• Lid is NOT included
• You will re-use yours
• This is the upper end cap only
• Latch assembly is NOT included
• It is a separate part number
• This is the lid and upper end cap only
• Requires partial dis-assembly of console
• Basic install instructions appear below
• They're included as a courtesy
• Use a qualified installer
• GM part number believed to be 22980387

DETAILS

This is the upper end cap that goes behind the lid. It is "Platinum" leather, with perforated leather accents. (It does not have suede on it. That is a different version.) It came from an assembly line left-over console that was never installed in a car, so it is in very good condition. Minor blemishes from rubbing/bumping against a neighbor console in storage, if any.

Your will transfer this part to your console. It is relatively easy to do but, if you have any doubts, you should have someone qualified installing this for you. We take no liability if you try to do it yourself and/or have someone who is not actually qualified do it and something goes wrong. We know it's not terribly difficult though. After-all, we had to dis-assemble the consoles to sell these parts and no one here had CTS console experience before we acquired these...

We have other parts for this console available too. Just drop us a message. If we have what you need, we'll set up a special listing for you.

Installation is not really hard. It is just a little time-consuming. (It takes us about 10 minutes, but we have done several of them.) Don't let these instructions scare you away. Good, detailed instructions will always be a little lengthy... The console does not need to come out of the vehicle. You just have to disassemble part of it. Basically, you're removing the tail section (if you want to replace the upper end cap) and the lid. Here goes...  

You will need to pull the lower plastic tail section from your console first. It is held on with six pressure connectors. (See our ads for the CTS rear assembly if you what to be sure of the locations.) If you cannot get your hand under the bottom edge of the lower tail, you will need to use a plastic pry tool to get in from each side and pry the very bottom out. Then you should be able to use your hands to pull the tail away, which will pop the remaining clips loose. Then you can use a philips bit to remove the two outside screws from the underside of the upper end piece. (So you might have to get your head down by the floor to look up and see them.) Remove the existing upper end cap. Repeat the process in reverse.

APPLICATIONS

• Cadillac CTS: 2014-2019